THE TANNERS CHOICE SYSTEM – TANNERS CHOICE PROTECTOR Forms a protective film that penetrates, bonding to the surface to create a tough barrier that resists spillages, abrasives and grime. When applied to freshly cleaned or new leather it dries to a natural soft sheen and will only show higher sheen when more than two coats are applied. Apply evenly using a clean, damp, non linting flannel. If weather is hot, a pure cotton cloth (not towelling) is best. Pour a small quantity of Protector onto pad or cloth and apply to back of the article first, in firm even strokes, slightly rubbing into edges and crevices. Never rub freshly applied coats as this will permanently smear or streak the partly dried surface. Repeat process, section by section, until the item has been coated. After the first coat has dried, (approx. 30 – 45 minutes) a second coat can be applied across the direction of the previous coat to increase protection. This may only be required on seat, cushions and arm rests where heavy wear protection is required. After surface has been protected it will be safe to use once the solvent smell has dissipated (usually a few hours after treatment).
Important: Before use, wear impervious chemical resistant gloves and safety glasses with side-shields. For professional use only.
Note: Refer to product information sheet for detailed application instructions.
➜ pH: n/a